top of page
Cylon Raider Battlestar Galactica (Series)
Click on pictures to enlarge.
Cylon Raider of the series by Moebius in 1:32 scale was released in 2012.
Inventory ... everything is there and we can start ...
Die Rohre mussten wieder selbst aufgebaut werden, da sie mit Lichtleiter versorgt werden sollten. Gut zu sehen links die Originalen rechts die neuen.
Das Blitzmodul (rot) und die Platine für den Visor. Diese kommt aus den USA und ist passgenau für das Modell.
The installation went largely without any problems.
Ein wenig musste gefeilt werden bis er passte.
Meine Lieblingstätigkeit....
ABKLEBEN...
ABKLEBEN...
The drives are also connected to the board and flicker a little.
Der Ständer ist wieder eine ausgediente Tischlampe vom Flohmarkt.
Fast etwas überdimensioniert für das kleine Modell.
ABKLEBEN.....Bei der Lackierung habe ich mich nicht an die Vorgaben gehalten und Alclad II verwendet.
The circuit board for the visor runs with only 3 volts and the blitzer circuit board from 9 volts, so a voltage reduction device from 9 volts to 3 volts had to be installed.
Fertig...Die Bauzeit betrug ca. 3 Wochen.
bottom of page